# What is the ball end of a hex key for?

Table of Contents

## What is the ball end of a hex key for?

The ball end makes it easier to slide the key into the receiving slot. It allows you to reach at an offset 30 degree angle so that you can feel your way to the needed position much faster – great for blind or difficult areas to reach or if the bolt or screw is close to an obstruction on one side.

**What is equivalent to a 15mm wrench?**

SAE to Metric Conversion Chart

SAE | Metric | Inch |
---|---|---|

9/16″ | 0.563 | |

15mm | 0.591 | |

19/32″ | 0.594 | |

5/8″ | 0.625 |

### What is the equivalent of 19 32?

getcalc.com’s fraction to decimal calculator to find what’s an equivalent decimal for the fractional number 19/32….How to Write 19/32 as a Decimal?

Fraction | Decimal | Percentage |
---|---|---|

21/32 | 0.6563 | 65.63% |

20/32 | 0.625 | 62.5% |

19/32 | 0.5938 | 59.38% |

18/32 | 0.5625 | 56.25% |

**What is 19 out of 32 as a percentage?**

59.375%

## Where is 1/16 inch on a tape measure?

The 1/16-inch mark is the absolute shortest line on the tape measure. It is also the first line that you will encounter after or before a whole-inch mark.

**What does 1/4 look like on a ruler?**

If you counted in 1/4 inches on a ruler, you’d see that the fourth line after 0 inches equals 1/4 inch, the eighth line equals 2/4 (1/2) inch, and the 12th line equals 3/4 inch. Example: Say you’re measuring a piece of cloth and the ruler ends at the fourth line after the 10-inch mark.

### Can you simplify 6 16?

What is 6/16 Simplified? – 3/8 is the simplified fraction for 6/16.

**How wide is 3/16 of an inch?**

Fraction, Decimal, and Millimeter Equivalent Measurements

Fraction | Decimal | Millimeters |
---|---|---|

1⁄8“ | 0.125 | 3.175 |

3⁄16“ | 0.1875 | 4.7625 |

1⁄4“ | 0.25 | 6.35 |

5⁄16“ | 0.3125 | 7.9375 |